1. Self-rotation automatic spraying machine routine maintenance
1.1. Each class: a. Wash the pipe with guns, paint machine, spray gun until the clean and no residue.
B. Remove the spray gun and the nozzle and wash it with a washbasin.
1.2. Daily: a. The entire machine to clean up, especially the spray booth, for the paint machine, spray room, waste treatment tower, up and down the table to clean up, wipe clean.
1.3. Weekly: a. Adjust the rotation belt tension, check the wear status, if the red wear-resistant layer of serious wear or tear should be replaced.
B. Check whether the automatic refueling oil is sufficient to replenish in time.
C. Rotate the electrostatic precipitator gun to clean the dust and clean the air.
D. Sprinkler exhaust fan clean: open the fan clean door rub, knock paint slag clean.
E. Air filter cotton cleaning.
caveat
Electrostatic dust guns must be cleaned regularly, otherwise the electrostatic discharge may cause a fire when the weather is dry.
The following are the same as the "
1.4. Monthly: a. The drive chain plus lubricating oil.
B. The entire machine once a rule pole, paint pieces removed clean.
C. Gun action piston plus lubricant.
D. Fan clean up: the wheel out to clean up the clean paint residue, and the wind wheel and volute wall coated with butter to prevent paint.
E. Sprinkler water curtain, sink and outlet pipe clean.
F. Exhaust pipe cleaning
G. Air filter cotton replacement.
H. Exhaust gas treatment tower filter wet Lian replacement.
I. Exhaust gas treatment tower sprayer, spiral whirlpool, tower wall, drain funnel clean.
1.5. Each year: a. Replace the gears of each drive with the gearbox.
2. Safety matters
1. Because the equipment is a moving machine, so as long as the equipment in the state of power, be careful not to your body and clothing equipment for the operation of the device into or hanging injury.
2. Spray paint in the work, is strictly prohibited to open the clean door or fan door, so as to avoid personal injury.
3. Equipment placement area should keep the air circulation and the environment is dry, is strictly prohibited in the equipment and its work area stacking debris caused by clogging, so as not to cause mechanical accidents.
4. Because the equipment is a sporty machine, you must be protected against self-protection during use and maintenance, and we are not responsible for any safety problems caused by this equipment
5. Equipment for the spraying machine In order to improve the efficiency of products to improve the yield, please keep the equipment to keep the environmental sanitation in a timely manner, is strictly prohibited accumulation of paint on the equipment
1.1. Each class: a. Wash the pipe with guns, paint machine, spray gun until the clean and no residue.
B. Remove the spray gun and the nozzle and wash it with a washbasin.
1.2. Daily: a. The entire machine to clean up, especially the spray booth, for the paint machine, spray room, waste treatment tower, up and down the table to clean up, wipe clean.
1.3. Weekly: a. Adjust the rotation belt tension, check the wear status, if the red wear-resistant layer of serious wear or tear should be replaced.
B. Check whether the automatic refueling oil is sufficient to replenish in time.
C. Rotate the electrostatic precipitator gun to clean the dust and clean the air.
D. Sprinkler exhaust fan clean: open the fan clean door rub, knock paint slag clean.
E. Air filter cotton cleaning.
caveat
Electrostatic dust guns must be cleaned regularly, otherwise the electrostatic discharge may cause a fire when the weather is dry.
The following are the same as the "
1.4. Monthly: a. The drive chain plus lubricating oil.
B. The entire machine once a rule pole, paint pieces removed clean.
C. Gun action piston plus lubricant.
D. Fan clean up: the wheel out to clean up the clean paint residue, and the wind wheel and volute wall coated with butter to prevent paint.
E. Sprinkler water curtain, sink and outlet pipe clean.
F. Exhaust pipe cleaning
G. Air filter cotton replacement.
H. Exhaust gas treatment tower filter wet Lian replacement.
I. Exhaust gas treatment tower sprayer, spiral whirlpool, tower wall, drain funnel clean.
1.5. Each year: a. Replace the gears of each drive with the gearbox.
2. Safety matters
1. Because the equipment is a moving machine, so as long as the equipment in the state of power, be careful not to your body and clothing equipment for the operation of the device into or hanging injury.
2. Spray paint in the work, is strictly prohibited to open the clean door or fan door, so as to avoid personal injury.
3. Equipment placement area should keep the air circulation and the environment is dry, is strictly prohibited in the equipment and its work area stacking debris caused by clogging, so as not to cause mechanical accidents.
4. Because the equipment is a sporty machine, you must be protected against self-protection during use and maintenance, and we are not responsible for any safety problems caused by this equipment
5. Equipment for the spraying machine In order to improve the efficiency of products to improve the yield, please keep the equipment to keep the environmental sanitation in a timely manner, is strictly prohibited accumulation of paint on the equipment
6. Electric box must maintain a good ventilation environment and is strictly prohibited in the electrical box stacking debris, to regularly clean up the dust inside the box to avoid fire, which directly or indirectly caused by personal injury or other property damage the company We do not assume any responsibility.
