The purpose of the gear oil pump: It is suitable for materials with non-corrosive properties with a lubricating property of less than 1500 cst, Du Yu 100 degree. The inlet and outlet are on the same level, with flanges and threaded connections. The maximum pressure is up to 4 MPa.
Application of stainless steel oil pump: Suitable for conveying corrosive medium with viscosity lower than 1500cst, with lubricating properties below 120 degrees. If the viscosity is greater than 1500cst, stainless steel high-viscosity pump is selected for a long time. The model is of course NYP or The LCX Roots pump is the best. However, the stainless steel oil pump is subject to a relatively small pressure of up to 2.5 MPa and a flow rate of up to 60 cubic meters per hour.
The purpose of the high-temperature oil pump: The pump body has been molded into a pump with a hollow sandwich during casting, and the pump body can heat and heat the medium conveyed by the pump through heat transfer oil, steam, cold water and other media. Role, suitable for conveying medium that is solidified at room temperature. Such as asphalt, resins and so on. If there is transport of corrosive materials with insulation, then stainless steel heat pump should be selected.
Since the height of the filling is close to the tower top, the water eliminator does not occupy much space, and the overall height of the cross-flow tower is small, which makes it relatively compact compared with counter flow type, and therefore lower air inlet speed and power consumption as well.
The cross-flow tower adopts a water distribution system that will let the water drop fall naturally by gravity. Thereby, water distribution holes are not easy to be blocked, as water distribution is even and maximizes the performance of the tower fillings. The inspection manhole also enables routinely maintenance without machine shutdown.
A lower part of the cross-flow tower filling is submerged in the water, so that the water flows through the surface of the filling and directly falls into the below tank, making low noise.
The cross-flow tower fan is located in the middle of the Cooling Tower, while the filling, on both sides of the tower. So the amount of splashing water is very small.
Cross Flow Cooling Tower,Cooling Tower Cools Water,Induced Draught Cooling Tower,Induced Draft Cross Flow Cooling Tower
Guangdong Jiema Energy Saving Technology Co.,Ltd , https://www.heatexchangerjm.com