Several technical problems and questions common to fire inspection cabinets

At present, fire inspection cabinets are often used in the basement of fire pumps, and are paired with a dual power control cabinet, a spray pump control cabinet, a hydrant pump control cabinet, and a mechanical emergency start cabinet

Control cabinet for a complete fire water system. The fire inspection cabinet also plays a major role in the water system, which is mainly used to start the box and dual power control of the fire itself.

The box performs a detection function, and its main potential function is to be able to test run the fire pump at regular intervals. The first is to test whether the function of the fire pump can function properly.

Second, to prevent rust and failure of the fire pump bearings.

So in daily life, including those problems encountered during installation and use, Xiaoxiang Xiaobian will summarize the following common questions for you, hoping to help

everyone.

1. Is the inspection cycle equipment of the automatic fire inspection cabinet automatically designed? Can it be set manually?

Answer: It will not be set automatically. It needs to be set by the staff. Which can be set as needed

2. Does the fire inspection cabinet inspect all the pumps together?

Answer: During the inspection of fire pumps, not all fire pumps are started together, but one by one, and the trial run time of each fire pump will not be less than 2 minutes. Low frequency

Inspection

3. Will the fire inspection cabinet stop the current working status if it receives a fire instruction?

A: When the fire inspection cabinet is still in the process of inspection, if it receives the fire control instruction from the control center, it will immediately exit the current inspection work and go in again.

Fire status.

4. In what ways does the fire inspection cabinet detect a fault?

A: When a fire inspection cabinet encounters a fault, it uses sounds, light sources and other alarm methods, and it has a memory function for the faults that have occurred.

When you choose a fire inspection cabinet, you must choose a qualified product from a regular factory, and a qualified product that can provide a fire product certification certificate and type inspection report.

Round Open Water Cooling Tower

The whole structure is solid and light;the body and water pond is manufactured with reinforced glass fibre (FRP glass fiber reinforced plastics),never being corrosive. The surface finish is added with ultraviolet inhibitor,which can resist sunshine attack and damage.

All steel and iron material is processed through galvanizing by dipping,Ocorrosion resisting and durable.

Special designed axial-flow type air blower applies belt reduction gear,reducing low noise and sufficient wind; tailor-made water-drop noise
reduction carpet to eliminate water sound.

Apply special design PVC water block curtain (water-stop) to prevents plashing) remarkably; pressure drop loss is slight and splashing loss i under 0.001%.

Special designed water sprinkler with big bore diameter,which won' t cause blocking but the sprinkling effect is very good. It is installed in the tower,so it won' t bee polluted by outside dust and foreign matters.


Apply cellular vacuum molding heat dissipation material, stagger arrangement surface has grooves and the heat exchange effect is especially good.


Water pond applies slant design, easy to wash, containing less water; the operating weight is lower, but the water tank is very big, so it won't absorb air.

The cooling tower support is light and solid, convenient to assembly no matter there is suspension iron rack or not.


Round Open Water Cooling Tower,Water Cooling Tower,Round Cooling Tower,Cool Water Towers

Wuxi Ark Fluid Science Technology Co., Ltd. , https://www.fangzhouarkfluid.com

This entry was posted in on