Relay data, signals and power are important prerequisites for industrial production. Distributed distribution box with Han connector performs this task. HARTING Technologies offers an alternative to manual wiring of Han connectors in the box.
The standard solution for the distribution box is to contact each connector through manual wiring (Figure 1). However, manual wiring has the obvious disadvantage that the main wiring workload is quite large in production and in high-sensitivity outdoor conditions such as shock and vibration. Elimination of system failure is not efficient, while the service there is also the risk of secondary failures.
Figure 1: In a box according to the conventional wiring
The purpose of HARTING's development efforts is to develop solutions that allow the continued use of proven Han® products while enabling them to avoid the disadvantages of manual wiring.
HARTING's solution is called HanOnBoard ?. In this solution, the Han? Connector is connected to a PCB (printed circuit board) using an adapter, which allows for fast and reliable data, signal and power distribution (Figure 2).
Figure 2: HanOnBoard? Solution Space-saving, robust, easy to manufacture and maintain
This solution eliminates the need for time-consuming and potential wiring problems that can easily lead to failures, based on trial and test Han® components, HARTING PCB adapters and HARTING PCB replacements combined with industrial manufacturing.
HanOnBoard? Compact, light weight, while sensitive to impact, the vibration is reduced to a minimum. Tedious troubleshooting was replaced with modern, fast module replacement. Avoid secondary service failure.
In addition, the special technological process guarantees that the field adjustment is still flexible enough when using printed circuit boards.
All HanOnBoard â„¢ components come from HARTING. Since the design of the overall solution is also done by HARTING, only one contact fitting is required, which significantly reduces the time required to develop a solution.
The feature of rubber tracks
(1). Less round damage
Rubber tracks cause less damage to roads than steel tracks and less rutting of soft ground than either steel tracks of wheel products.
(2). Low noise
A benefit to equipment operating in congested areas, rubber track products less noise than steel tracks.
(3). High speed
Rubber track permit machines to travel at a higher speed than steel tracks.
(4). Less vibration
Rubber tracks insulate machine and operator from vibration, extending the machine's lifetime and lowering operate fatigue.
(5). Low ground pressure
The ground pressure of rubber tracks equipped machinery can be fairly low, about 0.14-2.30 kg/ CMM, a major reason for its use on the wet and soft terrain.
(6). Superior traction
The added traction of rubber, track vehicles permits them to pull twice the load of wheel vehicles of the sane weight.
Application and Features:
1. Suitable for the small wheelchair.
2. Can load weight about300-400KG
3. Length can be adjusted.
4. Sprocket is available.
Characteristics of rubber track:
1). Less damage to the ground surface
2). Low noise
3). High running speed
4). Less vibration;
5). Low ground contack specific pressure
6). High tractive force
7). Light weight
8). Easy to change
Crawler Chasis,Crawling Chase,Undercarriage For Drilling Machine,Rubber Track For Drilling Rig
JIANGSU XI TEC ENVIRONMENTAL&DRILLING EQUIPMENT COMPANY CO.LTD , https://www.nbxitecdrilling.com