The reporter was informed that many domestic tire companies are on the verge of bankruptcy or project construction.
Five tire projects were suspended due to funding issues, all of which are private enterprises.
According to statistics, these companies have a total of 13 companies. Among them, there are 4 companies that have closed down and are about to close, including 1 state-owned enterprise, 2 private enterprises, and 1 Taiwan-funded enterprise, which will reduce tire annual production to 1.74 million full-steel tires and 8.57 million semi-steel tires. .
In addition, because of funding problems tire stop building five projects, all private enterprises, reducing the total planned annual capacity of 8.8 million steel tire, semi-steel tire 22 million.
Due to the fact that the environmental protection projects failed to stop the construction of three tire projects, all of them were privately-run enterprises. The total annual planned production capacity was reduced to 6.4 million full-steel tires and 24 million semi-steel tires.
Another reason for the suspension of construction of the tire project was the land permit issue. Its planned annual production capacity was 1.2 million full-steel tires.
Insiders told reporters that the reason for this situation is the tire market downturn. In recent years, a number of new projects have been introduced in the tire industry. Some of the projects are not high-grade, and they are redundant constructions, resulting in serious overcapacity at the low end and low product competitiveness. With the slowdown in economic growth, weak demand for tires and blocked exports, corporate capital pressure has increased significantly.
Plastic Flowmeter is a widely used instrument in water treatment engineering, mainly used for flow detection, usually installed after the water pump, to control the water intake of each structure, currently the most widely used are electromagnetic flowmeter and ultrasonic flowmeter. In the selection of the flowmeter, the first thing to consider is the corrosiveness of the measured medium to the flow-passing parts, so as to avoid affecting the service life of the flowmeter due to the corrosion of the medium; During the design and installation process of the flowmeter, the length of the straight pipes before and after the flowmeter needs to be considered. Usually, the principle of 5D before and 3D after the flowmeter is followed. Here, D is the inner diameter of the pipe. If the length is insufficient, the measurement accuracy will be affected. When using an ultrasonic flowmeter, the distance between the first 10D and the rear 5D must be met, and the distance from the flowmeter to the water pump must be more than 30D.
When selecting the type, the flow rate of the medium in the pipeline needs to be between the maximum value and the minimum value of the selected flowmeter, and avoid approaching the maximum or minimum value, so as to avoid affecting the measurement accuracy.
Plastic Flowmeter,Acrylic Flowmeter,Solenoid Valve,Liquid Filled pressure gauge
Hebei Chengda Water Technology Co.,Ltd. , https://www.arclionchengda.com